New Beetle L4-2.0L (AVH) (2005)
-
Hook wiring harness - 3 - into retainer - 7 - - arrow B -.
-
Install selector lever - 2 - onto selector shaft - 6 -.
-
Ensure that selector lever - 2 - pin engages into slide valve - 1 - - arrow A -. Reposition slide valve as necessary.
-
Install washer - 5 - and nut - 4 - onto selector shaft - 6 -.
Note:
-
Install the nut so the centralizing shoulder faces the washer and runs into it when installed.
-
Route the wiring harness below the selector lever.
-
Tighten nut to prescribed torque.
Note:
-
Carefully hold the selector lever - 1 - with a pair of pliers - 2 - so that the turning moments are not transmitted to the Multi-function TR switch
-F125-.
-
Ensure the slide valve - 3 - on the valve body (in which the selector lever engages) is not damaged.