New Beetle L4-2.0L (AVH) (2005)
Special tools and equipment
-
3158 Drift sleeve
-
V.A.G 1331 Torque wrench or equivalent
-
V.A.G 1332 Torque wrench or equivalent
Removing
-
Transmission is mounted in vehicle.
-
If installed, remove center and right part of insulation tray below engine/transmission.
-
Turn steering to right onto full lock stop.
-
Remove axle shaft.
-
Remove flanged shaft securing bolts by threading two bolts into flange and counterholding flanged shaft using a lever.
-
Place container under transmission.
-
Remove flanged shaft with spring.
-
Pry seal out with lever.
Installing