New Beetle L4-2.0L (AVH) (2005)
-
Loosen bolt -A- and nut -B-, until gear selector cable and actuating arm/gate selector cable are free to move in elongated holes.
-
Loosen bolt -C-, pull off foam seal in area of bolt -C- if necessary.
-
Insert gear lever jig.
-
Swing jig securing hook under mounting plate and tighten nut -D-.
-
Press gear lever into left-hand detent of sliding piece.
-
Press gear lever together with sliding piece to left onto stop (direction of arrow) and tighten sliding piece with bolt -E-.
-
Press gear lever into right-hand detent (direction of arrow).
-
Tighten bolt -C-.
-
Insert wedge and pin.
-
Slide wedge between gear selector and selector cover plate, make sure there is no play.
Note: Wedge must not lift gear lever.