New Beetle L4-2.0L (AZG) (2003)
NOTE: The X - axis window adjustment has been completed. Check dimension -A-, if not 65 mm±1 (2.52 in. to 2.60 in.) adjust again
-
Reinstall rubber grommets into bolt access holes
-
Reconnect cable to door lever and clip cable guide in position
-
Reconnect remaining electrical connectors to light, lock, etc.
-
Reinstall door trim panel -4- onto the door and secure with clips -6-
NOTE: Check door trim clips before reinstalling door trim panel and replace as necessary
-
Secure door trim panel with three Torx screws -3- along bottom of door and tighten to 4 Nm (35 in. lbs.)
-
Secure door trim panel with two phillips head screws -2- and tighten to 4 Nm (35 in. lbs.)
-
Reinstall handle trim -1-
-
With door closed and window in the full up position, check to see whether window top rear corner is 1.0 mm (0.40 in.) outward of rear
window glass
NOTE: This is the Y - axis window adjustment
-
If window is not outboard 1.0 mm adjust glass as follows:
-
On bottom of door at front and rear, remove rubber plugs covering nuts -A-
-
Loosen nuts -A- and adjust window in/out position -arrow- equally to achieve the 1.0 mm outward window position and tighten nuts