New Beetle L4-2.0L (AZG) (2003)
Wheel Speed Sensor: Service and Repair
Speed Sensor
Front, Axle Removing and Installing
Removing and installing speed sensor on front axle
Removing
-
Raise vehicle.
-
Disconnect speed sensor and speed sensor wiring connector -1-.
-
Remove bolt -2- from wheel bearing housing.
-
Disconnect ABS speed sensor from wheel bearing housing.
Installing
-
Before inserting speed sensor, clean hole inner surface and coat speed sensor with solid lubricant G 000 650.
-
Insert speed sensor into hole in wheel bearing housing and tighten bolt to 8 Nm (71 inch lbs.).
-
Connect speed sensor to speed sensor wiring.
-
Turn wheels fully to left and right lock and check clearance of speed sensor wiring.
Rear Axle, Removing and Installing
Speed sensor on rear axle, removing and installing
Removing
-
Raise vehicle.
-
Disconnect speed sensor and speed sensor wiring connector -1-.
-
Remove bolt -2- from stub axle.
-
Disconnect ABS speed sensor out of stub axle.
Installing
-
Before inserting speed sensor, clean hole inner surface and coat speed sensor with solid lubricant paste G 000 650.
-
Insert speed sensor into hole in stub axle and tighten bolt to 8 Nm (71 inch lbs.)
-
Connect speed sensor to speed sensor wiring.