New Beetle L4-2.0L (AZG) (2003)
Brake Light Switch: Adjustments
Brake Light Switch, Adjusting
Brake light switch, adjusting
Note:
Remove brake light switch to adjust.
-
Disconnect connector off brake light switch.
Removing
-
Disconnect connector off brake light switch.
-
Remove brake light switch by turning to left through 90° for vehicles up to m.y. 02.00; and 45° for vehicles from m.y. 03.00.
Installation of former brake light switch version (with corners; for vehicles up to m.y. 02.00;
-
Before installing, remove plunger completely.
CAUTION!
Keep brake pedal in the down position and hold pedal while installing switch.
-
Guide switch through mounting hole and secure by turning 90 clockwise.
-
Release brake pedal.
-
Connect brake light switch connector.
-
Check function of brake switch.
Installation of new brake light switch version (round; for vehicles from m.y. 03.00)
-
Before installing, remove plunger completely
-
Brake pedal must remain at rest position.
CAUTION!
Keep brake pedal in the up position and hold pedal while installing switch.