New Beetle L4-2.0L (AZG) (2003)
If the specification is not attained:
-
Check wiring for open circuit between 2-pin connector terminal 1 and central electrics using wiring diagram.
If the specification is obtained:
-
Remove inner plenum chamber cover, left:
-
Connect test box V.A.G 1598/31 to control module wiring harness. Engine control module is not connected by this action.
-
Check wiring for open circuit between test box and 2-pin connector using wiring diagram.
Terminal 2 + socket 39
Wire resistance: Max. 1.5 Ohms
If the specification is obtained:
-
Check wires for short to one another.
-
Additionally check wiring for short to battery positive or Ground.
If no wiring problem is detected:
-
Replace Engine Control Module (ECM).