New Beetle L4-2.0L (BEV) (2004)
-
Remove bolts -arrows-.
-
Disconnect left-side drive axle from transmission drive flange.
-
Pull wheel bearing housing with ball joint out from control arm.
-
Swing wheel with suspension strut outward and support.
-
Remove right-side inner CV joint protective cover from engine if installed.
-
Remove right-side drive axle.
-
Remove bolts -1- and -2- and remove transmission support.
-
Remove bolts -5- for steering gear.
-
For vehicles with TDI engine, remove bolts -6- for exhaust system.
-
Place engine/transmission jack VAG1383A with VAG1359/2 under subframe.
-
Remove bolts -3- and -4- for subframe.
-
Remove connecting link nut -7- from stabilizer bar.
-
Lower subframe with engine/transmission jack VAG1383A.
Installing
Before installing bolts for subframe, position steering gear on subframe and install bolts for steering gear.