New Beetle L4-2.0L (BEV) (2004)
Fig. 1 Installed position of double clamp
Work sequence
^
Position double clamp approximately 5 mm away from mark "A" (arrow -2-).
Note:
^
Mark "A" (arrow -I is valid for models with either a manual or an automatic transmission.
^
Mark "S" (arrow -I is not valid for the engine codes in this manual.
Fig. 2 Installed position of mounting
Angled side on base of mounting (arrow) points forward.
Fig. 3 Separating point on exhaust pipe
Special tools, equipment, testers, measuring instruments and auxiliary items required
^
Body saw e.g. VAG1523
Work sequence
^
Separate exhaust pipe at right angles at separating point (arrow -2-).
^
When installing, position repair double clamp -4- at side markings (arrows -1- and -3-). Tighten torque: 40 Nm