New Beetle L4-2.0L (BEV) (2004)
-
Pry out rest of seal using a screwdriver -A-.
-
B- Assembly lever
Installing
Install in reverse order. When doing this note the following:
-
Moisten outer edges and sealing lip of oil seal with ATF.
Installation position:
Open side of oil seal faces transmission.
-
Guide inner sealing lip -A- of oil seal carefully over transmission stub shaft -B-. Sealing lip must not roll back.
-
Press oil seal in as far as possible by hand (arrows).
-
Drive oil seal in onto limit stop of press piece T10176. Do not tilt seal when doing this.
-
Install left side axle shaft.
-
Check ATF level and top off if necessary.
-
Install sound insulation.
Flanged Shaft Oil Seal - Right Side, Replacing
Flanged shaft oil seal - right side, replacing
Special tools and equipment