New Beetle L5-2.5L (BPR) (2007)
Continuation for All
-
Disconnect brake lines from brake master cylinder and seal brake lines using plugs from repair kit (1H0 698 311 A).
-
Remove nuts from master brake cylinder.
-
Carefully remove brake master cylinder from brake booster.
Installing
-
Installation is in reverse order of removal.
Pay particular attention to the following:
-
When installing brake master cylinder onto brake booster, make sure push rod is correctly located in brake master cylinder.
-
After installing, bleed brake system:
‹› Vehicles with or without ABS Mark 20 IE up to 09.00 => [ Brake System Bleeding General Information ] See: Brake Bleeding/Service and
Repair/Brake System Bleeding General Information.
‹› Vehicles with ABS Mark 60 from 10.00 => [ Brake System Bleeding General Information ] See: Brake Bleeding/Service and Repair/Brake
System Bleeding General Information.
-
Bleed clutch.
-
Initiate basic setting.