New Beetle L5-2.5L (BPR) (2007)
^
Only replace as set
^
Affiliation to cylinder mark - B -
^
Installed location: Markings - A - point to belt pulley side
7 - Circlip
8 - Piston pin
^
If difficult to move, heat piston to 60° C
^
Removing and installing using a Pilot Drift VW 222 A
9 - Piston
^
Mark installed position and cylinder allocation
^
Arrow on piston face points toward belt pulley side
^
Install with piston ring compressor
10 - Piston rings
^
Offset gaps by 120°
^
Use piston ring pliers for removal and installation
^
Markings face toward piston crown
Bearing shells - installed positions
Bearing shell - 1 - with oil bore - arrow - for connecting rod.
Bearing shell - 2 - without oil bore for connecting rod cover.
-
Place bearing shells centrally into connecting rod and connecting rod cap.
Dimension - a - must be same at left and right.