New Beetle L5-2.5L (BPR) (2007)
Variable Induction Control Module: Service and Repair
Throttle Valve Control Module
Special tools, testers and auxiliary items required
‹› Hose clamps up to 25 mm dia. (3094)
‹› Torque wrench (VAG 1410)
‹› Spring type clip pliers (VAS 5024A) or hose clip pliers (VAS 6340)
Removing
‹› Observe the rules for cleanliness. Refer to => [ Clean Working Conditions ] See: Fuel Delivery and Air Induction/Service Precautions/Clean
Working Conditions/Multiport Fuel Injection.
-
Remove the engine cover.
-
Remove the intake hose - 4 - between the throttle valve control module (J338) and the Mass Air Flow (MAF) sensor (G70). To do so, disconnect
air hoses - 1 and 2 - (compress securing ring) and remove spring clamp - 3 -.
-
Disconnect the connector - 1 - and bleeder hose - 2 -.
-
Remove the bolts - arrows -.
‹› Seal the intake passage in the intake manifold using a clean cloth.
-
Clamp off the coolant hoses using (3094) and disconnect them from the throttle valve connections - arrows -.