volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Telematics Indicator Lamp (K186), Malfunction Recognition|Page 113 > < Telematics Indicator Lamp (K186), Malfunction Recognition|Page 111
Page 1
background image

Global Positioning System Module: Testing and Inspection
Telematics Control Module (J499), Configuring

Telematics

Telematics Control Module (J499), Configuring

Special tools, testers and auxiliary items required

‹› Vehicle Diagnostic, Testing and Information System ( VAS 5051B)

After replacement of the Telematics control module, it must be coded and configured for the OnStar system. Have the VIN and customer data ready. 

‹› Do not swap out any Telematics control modules between different vehicles! Each Telematics control module has a special identification and an

electronic serial number that matches the VIN. Using this data, the vehicle is identified by the OnStar Call Center and assigned to the respective
customer account. 

‹› If the configuration of the Telematics control module is not performed, OnStar service and other functions will not work so that the customer will

need to return to repair service.

Procedure:

‹› The Telematics control module was coded, refer to => [ Telematics Control Module , Coding ]. See: Telematics Control Module (J499), Coding

-

Make a note of the 8-digit Station Identification Number (STID) and the Electronic Serial Number (ESN) on the sticker on the Telematics control
module.

-

Connect (VAS 5051B).

-

In (VAS 5051B), select operating mode " Guided Fault Finding".

After all DTC memories have been queried, continue with.

If the STID number and ESN are not on the sticker of the new Telematics control module, continue as follows:

-

Using the Sprung button, select "Functions/Component selection" and the following menu options in the following sequence: 

‹› Body

‹› Electrical Equipment

‹› 01 - On Board Diagnostic (OBD) capable systems

‹› Telematics NAR

‹› Telematics NAR functions

‹› Check control module version

-

Make a note of the ESN and STID number on the display.

Continuation for all:

-

Using the Sprung button, select "Functions/Component selection" and the following menu options in the following sequence: 

‹› Body

‹› Electrical Equipment

‹› 01 - On Board Diagnostic (OBD) capable systems

‹› Telematics NAR

‹› Telematics NAR functions

Telematics Indicator Lamp (K186), Malfunction Recognition|Page 113 > < Telematics Indicator Lamp (K186), Malfunction Recognition|Page 111