New Beetle L5-2.5L (BPR) (2007)
Rear Cross-Member Bushing: Service and Repair
Hydraulic Bonded Rubber Bushings
Hydraulic Bonded Rubber Bushings
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)
‹› Engine/transmission jack (V.A.G 1383 A) with universal transmission support (V.A.G 1359/2)
‹› Brake pedal depressor (V.A.G 1869/2)
‹› Tensioning strap (T10038)
‹› Wheel hub support (T10149)
‹› Hydraulic cylinder (VAS 6178)
‹› Foot pump (VAS 6179)
‹› Basic set for hydraulic bearing (VAS 6180)
CAUTION!
After removing the hydraulic bonded rubber bushing, only " conventional" bonded rubber bushing may still be installed.
Replacement must be performed on both sides of rear axle. A mixed installation is not permitted.
Removing
-
Measure dimension from center of wheel to lower edge of wheel housing => [ Lifting into Curb Weight Position ] See: Service and
Repair/Procedures/Rear Suspension.
-
Insert brake pedal depressor (V.A.G 1869/2 ).
-
Raise vehicle to installation height.
-
Remove wheels.
-
Disconnect brake lines - arrow A - and remove clip.
-
Pull left brake hose out of holder - 2 -.
-
Pull right brake hose out of rear axle.
-
Remove parking brake cable from holders - arrow B -.