New Beetle L5-2.5L (BPR) (2007)
Transmission Speed Sensor: Testing and Inspection
Transmission Output Speed (RPM) Sensor G195, Checking
Transmission Output Speed (RPM) Sensor G195, Checking
Special tools, testers and auxiliary items required
-
Multimeter
-
Wiring diagram
Requirements
-
The Transmission Control Module (TCM) J217 fuse OK.
-
The battery voltage must be at least 12.5 Volts.
-
All electrical consumers must be switched off.
-
The parking brake must be engaged.
-
The selector lever must be in the "P" position.
-
The Ground (GND) connections to transmission must be OK.
-
Ignition switched off.
Test procedure
-
Perform a preliminary check to verify the customers complaint.
Start diagnosis
-
Disconnect the Transmission Output Speed (RPM) Sensor G195 electrical harness connector - 1 -.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
Repair any damage found to the electrical harness connector.
If the electrical harness connector is OK:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Adapter F/VAG1598 (68 Pin) VAG1598/22.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Transmission Control Module (TCM) J217.
-
Using a multimeter, check the Transmission Output Speed (RPM) Sensor G195 electrical harness connector terminals to the Transmission Control