New Beetle L5-2.5L (BPR) (2007)
/Page-1688002.png)
3
Tapered roller bearing outer race
‹› Pulling out => [ Pulling outer race/tapered roller bearing out
of transmission housing ] See: Overhaul/Differential
‹› Pressing in => [ Pressing outer race/tapered roller bearing into
transmission housing ] See: Overhaul/Differential
4
Tapered roller bearing inner race
‹› Pulling off => [ Pulling off inner races/tapered roller bearing ] See: Overhaul/Differential
‹› Pressing on => [ Pressing on inner races/tapered roller bearing ] See: Overhaul/Differential
5
Differential housing
‹› With drive gear for final drive
‹› Thrust washer union installed to differential housing => [ On some transmissions the thrust washer union
was made with a ridge in area of holes. ] See: Overhaul/Differential
6
Tapered roller bearing inner race
‹› Pulling off => [ Pulling off inner races/tapered roller bearing ] See: Overhaul/Differential
‹› Pressing on => [ Pressing on inner races/tapered roller bearing ] See: Overhaul/Differential
7
Tapered roller bearing outer race
‹› Pressing out => [ Pressing tapered roller bearing outer race out
from clutch housing ] See: Overhaul/Differential
‹› Pressing in => [ Pressing outer race/tapered roller bearing into
clutch housing ] See: Overhaul/Differential
8
Clutch housing
9
Sleeve
‹› For mounting of seal => [ (Item 10) Seal ]
‹› Removing and installing => [ Transmission and Clutch Housing ] See: Service and Repair/Overhaul/Transmission and Clutch Housing.
10
Seal
‹› Replace with transmission installed => [ Removal and Installation ] See: Table of Contents.
11
Oil seal and sleeve as one part
‹› If seal is damaged, replace seal and sleeve together => [ Removal and Installation ] See: Table of Contents.
12
Countersunk screw, 25 Nm
‹› Screw together with threaded piece => [ (Item 20) Threaded piece ]
13
Flange shaft
‹› Removing and installing => [ Removal and Installation ] See: Table of Contents.
14
Spring for flange shaft
‹› Rear flanged shaft installed
15
Thrust washer
