New Beetle L5-2.5L (BPS) (2006)
/Page-588008.png)
-
Using engine/transmission jack, lift wheel bearing housing until dimension - a - has been reached.
CAUTION!
‹› Do not lift or lower vehicle with the engine/transmission jack below the vehicle.
‹› Do not leave Engine/transmission jack below the vehicle any longer than necessary.
-
Tighten respective bolts/nuts.
-
Lower wheel bearing housing.
-
Remove engine/transmission jack from below vehicle.
-
Remove wheel hub support (T10149).
Front Axle Toe, Adjusting
Front Axle Toe, Adjusting
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)
If values are outside tolerance, transverse inclination must be checked first and compensated if necessary => [ Vehicle Transverse Inclination Neutral
Position ] See: Wheel Alignment, Preparing to Measure.
-
Loosen lock nut - 1 -.
-
Set toe by twisting left and/or right tie rod.
