New Beetle L5-2.5L (BPS) (2006)
-
From inside, assemble pressure piece - 4 - with wide collar to wheel bearing housing and special nut - 5 -.
-
Press in wheel bearing by actuating pump.
-
Insert securing ring with needle-nose pliers.
1
Wheel bearing
2
Thrust piece (E-13-1)
3
Hollow piston cylinder ( HKZ-15)
4
Thrust piece (E-10)
5
Special nut (E-8-214) and tie bolt
Wheel Hub, Installing
-
Put wheel hub - 1 - and hollow piston cylinder - 2 - with tie bolt onto wheel bearing.
-
From inside, assemble special nut - 4 - and pressure piece - 3 - with collar to special nut.
-
Press in wheel hub by actuating pump.
1
Wheel hub
2
Hollow piston cylinder ( HKZ-15)
3
Thrust piece (E-5)
4
Special nut (E-8-214) and tie bolt
Installation is in reverse order of removal. Note the following:
-
Tighten bolts for control arm and ball joint on to old marks.