New Beetle L5-2.5L (BPS) (2006)
If the specified value was obtained:
-
Using a multimeter, check the Secondary Air Injection (SAI) Pump Motor (-V101-) electrical harness connector terminal 2 to the Secondary Air
Injection (SAI) Pump Relay (-J299-) connector terminal 2 (relay 87).
Specified value: 0.5 ohms or less.
If the specified value was Not obtained:
-
Check the voltage supply circuit between the Secondary Air Injection (SAI) Pump Relay (-J299-) and the Secondary Air Injection (SAI) Pump
Motor (-V101-) for an open or high resistance. Refer to Wiring Diagrams.
-
Repair the circuit as necessary.
If the specified value was obtained:
-
Perform the Secondary Air Injection Pump Relay test to find cause of no voltage to the SAI pump motor.
Final procedures
After the repair work, the work steps below must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Readiness Code.