New Beetle L5-2.5L (BPS) (2006)
Clutch Switch: Service and Repair
Clutch Pedal Switch
In order to assure secure fitting, clutch pedal switch (F36) must not be installed more than once.
Removing
-
Slide driver's seat toward rear as far as possible and bring steering wheel to highest position.
-
Remove cover in driver's side footwell.
-
Disconnect connector from clutch pedal switch ( F36).
-
Rotate clutch pedal switch (F36) at housing 45 degrees toward left and remove from mount.
Installing and Adjusting
Installation is in reverse order of removal. Note the following:
During installation of clutch pedal switch, clutch pedal always remains in rest position (not operated).
‹› Check clutch pedal switch first.
‹› Stop - A - must be located in front of section - B -.
‹› Stop - C - is then located directly below take-up hook.
If this is not the case, plunger must not be pulled out.