New Beetle L5-2.5L (BPS) (2006)
-
Place Engine/transmission jack (V.A.G 1383 A ) underneath.
-
Remove mounting bracket bolt - 1 - at rear axle on both sides.
Vehicles in which point of bolt - 2 - points toward vehicle exterior (only valid for right side of vehicle):
-
Loosen bolt - 2 - and remove nut.
-
Mark installation position of mounting bracket for rear axle and remove mounting bracket from chassis.
-
Pull bolt - 2 - out of mounting bracket.
Continuation for All
-
Lower rear axle using engine/transmission jack ( V.A.G 1383 A).
-
Secure rear axle using tensioning belt ( T10038 ) over exhaust system suspension.
With Automatic Headlight Range Control
-
Remove coupling rod of left rear level control system sensor (G76) from rear axle => [ Left Rear Level Control System Sensor Overview ] See:
Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair/Left Rear Level Control System Sensor Overview.
Continuation for All
CAUTION!
Place engine/transmission jack (V.A.G 1383 A ) with universal transmission support (V.A.G 1359/2 ) under control arm (danger of
accident from components falling out when pulling out bushing).