New Beetle L5-2.5L (BPS) (2006)
Rear Subframe: Service and Repair
Rear Axle Beam
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)
‹› Engine/transmission jack (V.A.G 1383 A) with universal transmission support (V.A.G 1359/2)
‹› Brake pedal depressor (V.A.G 1869/2)
Removing
-
Measure dimension from center of wheel to lower edge of wheel housing => [ Lifting into Curb Weight Position ] See: Service and
Repair/Procedures/Rear Suspension.
-
Insert brake pedal depressor (V.A.G 1869/2 ).
-
Operate brake pedal using brake pedal depressor.
-
Remove bolts - 1 - while vehicle stands on wheels. If necessary, lift vehicle until bolts are accessible.
-
Loosen wheel bolts.
-
Raise vehicle to installation height, taking tension off coil springs.
-
Remove wheels.
Secure vehicle to lifting platform.
Vehicle must be secured to lift arms of lifting platform before rear axle is removed.
CAUTION!
If a vehicle is not secured, there is danger that the vehicle could slip off the hoist!
-
Remove plug from longitudinal member - 3 - and pull in tensioning strap (T10038).