New Beetle L5-2.5L (BPS) (2006)
If the specification is not obtained:
-
Remove the drive plate again and install shim - 2 -. Tighten bolts - 3 - to 30 Nm again and repeat the measurement.
If the specified value is OK:
-
Tighten the bolts to 60 Nm + 90° (1/4) additional turn, the additional turn may occur in several stages).
The rest of the installation follows the reverse of the removal procedures. When doing this note the following:
‹› Remove the (T40069) from the cylinder block and install the locking bolt (30 Nm).