New Beetle L5-2.5L (BPS) (2006)
5
Bushing
6
Seal
‹› Pry out with screwdriver
‹› Installing => [ Drive in sealing ring to stop. ] See: Service and Repair/Overhaul/Shift Mechanism
7
Hex nut, 23 Nm
‹› Self-locking
‹› Always replace
8
Transmission shift lever
‹› Insert so that master spline aligns with shift rod
‹› Can be replaced with shift mechanism installed
‹› Installed position => [ Installation Position of Transmission Shift
Lever/Actuator Lever ] See: Shift Linkage/Shift Cable/Service and Repair
9
Cap
‹› For transmission breather
10
Lock washer
11
Sealing cap
12
Spring
‹› Not installed in all transmissions
‹› Reinstall if present
Boot, Disconnecting From Shift Lever and Installing on Shift Knob
Boot, Disconnecting from Shift Lever and Installing on Shift Knob
Special tools, testers and auxiliary items required
‹› Hose clamp pliers (V.A.G 1275)
-
Turn inner side of cover toward outside.
-
Carefully press off clamping sleeve - arrows - using a screwdriver, while doing so pull off shift knob.