volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Body - Rear Deck Lid Is Difficult to Close|Page 13505 > < Campaign - Rear Deck Lid Strut Replacement|Page 13499
Page 1
background image

Trunk / Liftgate Shock / Support: Customer Interest
Body - Rear Deck Lid Is Difficult to Close

Condition

Customer States, Rear Deck Lid Hard to Close Customer states rear deck lid not closing properly.

55 06 06 Oct. 20, 2006, 2013141

Technical Background

To reduce efforts to close and latch the rear deck lid, replacement struts with reduced closure force and a softer lock dampening rubber may be installed.

Due to the stiffness of the original lock dampening rubber, the rear deck lid may be difficult/hard to close.

Production Solution

Installation of reduce force deck lid struts and a softer lock dampening rubber were incorporated into production beginning with VIN: VIN
1Y_7M405011.

Service

-

Raise the rear deck lid and note support strut force number as indicated.

If the number is 380N:

-

Replace struts with Part No: 1Y0827550D (330 N), see Repair Manual Group 55, Bonnet, flaps, cab, central locking, Rear Lid Assy Overview in
ElsaWeb), and install lock dampening rubber Part No. 1C0827589B following the procedure below.

Tip: Part number(s) are for reference only. Always see ETKA for the latest part(s) information.

If the number is 330N:

-

No further action required.

Install improved lock dampening rubber Part No. 1C0827589B:

-

Open rear deck lid.

-

Remove rear deck lid trim panel (see Repair Manual, Body Interior, Group 70 - Interior trim on ElsaWeb).

-

Remove Lock housing cover.

Tip: To remove lock housing cover, gently pry between the locking pawl and cover guides while pulling down on cover. Underside of cover
shown for ease of location identification.

Body - Rear Deck Lid Is Difficult to Close|Page 13505 > < Campaign - Rear Deck Lid Strut Replacement|Page 13499