Service and Repair for Camshaft in New Beetle Convertible L5-25L (BPR) Engine (2007)
-
Install the camshafts correctly into the guide frame.
‹› Intake camshaft with sensor wheel - 2 - points toward the Camshaft Position (CMP) sensor (G40) - 1 -.
‹› Camshafts must lie exactly in the axial bearings - 3 - in the guide frame.
‹› Seal ends - 4 and 5 - must point upward or downward, they must not point to the side under any circumstances.
-
With the camshafts installed in the guide frame, hold the camshafts firmly in place and turn over and install the guide frame.
-
Rotate the camshafts until the threaded holes - arrows - point upward.
-
Check whether the camshafts still lie exactly in the axial bearings of the guide frame.
-
Install the (T40070) as shown to the camshafts and tighten the bolts to 20 Nm.