New Beetle Convertible L5-2.5L (BPR) (2007)
Compressor Clutch: Service and Repair
A/C Clutch
A/C Clutch
Special tools, testers and auxiliary items required
‹› Pin wench (VAS3212A) (or equivalent)
‹› Two arm puller
‹› Three arm puller
‹› Depth gauge
‹› Torque wrench (5-50 Nm) or equivalent (VAG 1331 )
‹› It is not necessary to discharge the refrigerant system to remove and install the A/C Clutch.
‹› If A/C Clutch is to be removed with compressor installed, first do the following:
‹› Remove ribbed belt.
‹› Remove intercooler (engine code ALH only).
‹› If A/C Clutch is to be removed with compressor removed, first discharge refrigerant system => [ A/C Refrigerant System, Discharging ] See:
Service and Repair/Procedures/A/C Refrigerant System, Discharging.
Removing
Hex Nut
-
Remove hex nut while counter-holding with 3213A or equivalent commercially available 2 hole pin wrench (with 4 mm pins).
‹› Tightening torque: 15 Nm
Clutch Plate