New Beetle Convertible L5-2.5L (BPR) (2007)
/Page-1130002.png)
starter is supplied to the ECM at the T121/30.
Currently there is no Guided Fault Finding test plan for DTC P3047. Test procedure should be performed with Digital Oscilloscope (DSO) after relay
-J434-, which is located in the thirteen position of the auxiliary relay panel, above the relay panel (reference stamping 465). Use the DSO to verify the
correct delay time (210 ms-300 ms). P3047 fault occurs at less than 180 ms or greater than 1000 ms.
Loose or poor connections may illuminate the MIL. Inspect the ECM -J220- at the T121/30 for a similar condition as shown.
Production Solution
Engine harness supplier countermeasure as of VIN number:
New Beetle: 3VWRW21C88M511407
New Beetle Convertible: 3VWRF31Y08M409892
Service
TIP:
DTC P3047 "Activation Starter Relay 2 Short to B+" CAN be displayed on VAS 5051/5052 scan tool or other enhanced scan tools.
NOTE:
DO NOT replace the Engine Control Module (ECM) -J220- for this concern.
^
Once the concern has been identified, repair as necessary, see ElsaWeb.
Warranty
Information only.
Required Parts and Tools
No Special Parts required.
No Special Tools required.
Additional Information