volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Oxygen Sensor Before Catalytic Converter, Checking Heater|Page 5389 > < Oxygen Sensor Before Catalytic Converter, Checking Heater|Page 5387
Page 11
background image

Specified value: 1.5 ohms Max.

If the specified value was Not obtained:

-

Check the wiring for an open, high resistance, short circuit to each other, Battery (+) or Ground.

-

Check the electrical harness connector for damage, corrosion, loose or broken terminals.

-

If necessary, repair the faulty wiring connection.

If no malfunction is found in the wiring and the voltage was Not OK:

-

Replace the Motronic Engine Control Module (ECM) (J220). Refer to the Repair Information.

Final procedures

After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and

Procedures/Diagnostic Modes 01 - 09. 

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing

and Procedures/Diagnostic Modes 01 - 09.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive

Cycles and Readiness Codes/Readiness Code.

Oxygen Sensor After Catalytic Converter, Checking Heater

Diagnostic Procedures

Oxygen Sensor after Catalytic Converter, Checking Heater

‹› Vehicle must be raised before electrical harness connector for the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) is

accessible.

‹› When servicing terminals in harness connector of Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130), use only

gold-plated terminals.

Special tools, testers and auxiliary items required

‹› Multimeter.

‹› Wiring diagram.

Test requirements

‹› The Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) fuse 15 in Fuse box B is OK.

‹› Battery voltage at least 12.5 volts.

‹› All electrical consumers such as, lights and rear window defroster, switched off.

‹› Vehicles with automatic transmission, shift selector lever into position " P" or "N".

‹› A/C switched off.

Oxygen Sensor Before Catalytic Converter, Checking Heater|Page 5389 > < Oxygen Sensor Before Catalytic Converter, Checking Heater|Page 5387