New Beetle Convertible L5-2.5L (BPR) (2007)
Accelerator Pedal Position Sensor: Testing and Inspection
Diagnostic Procedures
Throttle Position Sensor/Accelerator Pedal Position Sensor 2, Checking
Special tools, testers and auxiliary items required
‹› Multimeter.
‹› Wiring diagram
Test requirement
‹› The Motronic Engine Control Module (ECM) ( J220) fuses OK.
‹› Battery voltage at least 12.5 volts.
‹› All electrical consumers such as, lights and rear window defroster, switched off.
‹› Vehicles with automatic transmission, shift selector lever into position " P" or "N".
‹› A/C switched off.
‹› Ground connections between engine/transmission/chassis OK.
‹› Use only gold-plated terminals when servicing the electrical harness connector terminals in Throttle Position (TP) Sensor (G79 )/Accelerator
Pedal Position Sensor 2 (G185).
Test procedure
-
Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Preliminary Check
Start diagnosis
-
Remove the drivers side storage compartment. Refer to the Repair Information.
-
Disconnect the Throttle Position (TP) Sensor ( G79)/Accelerator Pedal Position Sensor 2 (G185 ) 6 pin electrical harness connector - 2 -.