New Beetle Convertible L5-2.5L (BPR) (2007)
-
Pull off bearing inner race from stub axle.
Only use puller - A - with tension bracket, e.g. (Kukko 204-2) (commercial type)..
Installing
-
Push wheel bearing/wheel hub unit onto stub axle as far as it will go.
-
Install on installation sleeve wheel brg. (3420 ) and pull on wheel bearing/wheel hub unit until it stops.
Make sure that wheel hub/wheel bearing unit is not tilted!
-
Remove installation sleeve wheel brg. (3420).
-
Use a new 12 point nut - A - and tighten, tightening specification => [ Rear Axle ] See: Specifications/Rear Suspension/Rear Axle Component
Tightening Specifications.