New Beetle Convertible L5-2.5L (BPR) (2007)
If any of the specified values are not obtained:
-
Replace the Transmission Fluid Temperature Sensor G93.
If the specified values are obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Adapter F/VAG1598 VAG1598/22.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Transmission Control Module (TCM) J217.
-
Using a multimeter, check the Transmission Fluid Temperature Sensor G93 electrical harness connector terminals to the Transmission Control
Module (TCM) J217 electrical harness connector T52 terminals for resistance.
Transmission Fluid
Transmission Control Module (TCM)
Temperature Sensor G93
J217 electrical connector T52
electrical harness connector
terminals or test box sockets
terminal
1
45
2
8
Specified value: 1.5 Ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
If necessary, repair the faulty wiring connection.
If no malfunction was found in the wiring and the resistance was not OK:
-
Replace the Transmission Fluid Temperature Sensor G93.
-
Erase the DTC memory.
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and resistance was OK:
-
Replace the Transmission Control Module (TCM) J217.
-
Assembly is performed in the reverse of the removal.
Final procedures
1. Check the DTC memory.
2. If necessary, erase DTC memory of the Transmission Control Module (TCM) J217.
3. Generate readiness code.
End diagnosis.