New Beetle Convertible L5-2.5L (BPS) (2006)
Electronic Brake Control Module: Locations
ABS Mark 60
Electrical/electronic components and installing locations
1- ABS hydraulic unit -N55
^
Located on left of engine compartment.
^
The ABS hydraulic pump -V64- and the inlet/outlet valves in the hydraulic unit are checked by On Board Diagnostic (OBD)
^
The ABS hydraulic pump -V64- and valve block must not be separated from one another
^
When changing the hydraulic unit, always seal the old part with the plugs from the repair set Part No. 1 HO 698 311 A
2- ABS Control Module (w/EDL) -J104
^
Location- on hydraulic unit on left of engine compartment
^
Checked by On Board Diagnostic (OBD)
^
Do not disconnect multi-pin connector before successfully completing OBD. Switch ignition off before separating connection.
Vehicles with ABS/ESP only
-
When the ABS Control Module (w/EDL) -J104- is replaced, a zero compensation must be performed
-
Initiate basic settings, Perform display group numbers 060, 063 and 066