New Beetle Convertible L5-2.5L (BPS) (2006)
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J220). Refer to the Repair Information.
-
Using a multimeter, check the Throttle Position (TP) Sensor (G79)/Accelerator Pedal Position Sensor 2 (G185) electrical harness connector
terminals to the Motronic Engine Control Module (ECM) (J220) electrical connector T121 for an open circuit.
Specified value: 1.5 ohms max.
If the specified value was Not obtained:
-
Check the wiring for a short circuit to each other, Battery (+) or Ground or high resistance.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no fault is detected in the wiring and the voltage supply was OK:
-
Replace the Throttle Position (TP) Sensor (G79 )/Accelerator Pedal Position Sensor 2 (G185). Refer to the Repair Information.
If no fault is detected in the wiring and the voltage supply was Not OK:
-
Replace the Motronic Engine Control Module (ECM) (J220). Refer to the Repair Information.
-
Install the drivers side storage compartment.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09.