New Beetle Convertible L5-2.5L (BPS) (2006)
fuse/relay panel) S7 for an open circuit, short to ground (GND) or a short to Battery (+).
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Install the Adapter F/VAG1598 (68 Pin) VAG1598/22.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Transmission Control Module (TCM) J217.
-
Using a multimeter, check the Multi-Function Transmission Range (TR) Switch F125 electrical harness connector terminals to the Transmission
Control Module (TCM) J217 electrical harness connector T52 terminals for an open circuit.
Multi-Function Transmission
Transmission Control Module (TCM)
Range (TR) Switch F125
J217 electrical connector T52
electrical harness connector
terminals or test box sockets
terminals
1
47
3
1 and 2
4
1 and 2
5
22
7
10
8
21
9
36
Specified value: 1.5 Ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
If necessary, repair the faulty wiring connection.
If no malfunction was found in the wiring and the resistance was not OK:
-
Replace the Multi-Function Transmission Range (TR) Switch F125.
-
Erase the DTC memory.
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and resistance was OK:
-
Replace the Transmission Control Module (TCM) J217.
-
Assembly is performed in the reverse of the removal.
Final procedures
1. Check the DTC memory.
2. If necessary, erase DTC memory of the Transmission Control Module (TCM) J217.
3. Generate readiness code.