New Beetle GLS L4-1.8L Turbo (AWV) (2001)
/Page-426002.png)
New: 0.05 to 0.31 mm
Wear limit: 0.37 mm
^
Check radial clearance with Plastigage:
New: 0.01 to 0.06mm
Wear limit: 0.09 mm
^
Do not rotate crankshaft when checking radial clearance
7. Cylinder block
^
Checking cylinder bores, Refer to Fig. 4
8. Connecting rod bearing cap
^
Note installation position
9. Oil spray jet
^
For piston cooling
10. Pressure relief valve, 27 Nm
^
Opening pressure: 1.3 to 1.6 bar
11. Connecting rod bolt, 30 Nm +1/4turn (90°) further
^
Always replace
^
Oil threads and contact surface
^
To measure radial clearance use old bolts
^
To measure radial clearance tighten to 30 Nm but not further
Fig. 1 Checking piston ring gap
Special tools and equipment
^
Feeler gauges
-
Push ring squarely from above down to approximately 15 mm from bottom end of cylinder.
Fig. 2 Checking ring to groove clearance
Special tools and equipment
^
Feeler gauges
