New Beetle GLS L4-1.8L Turbo (AWV) (2001)
/Page-770017.png)
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If the LED does not flash and the Secondary Air Pump Relay -J299- does not click:
-
Proceed with Output Diagnostic Test Mode (DTM) until completed.
-
Switch off ignition.
-
Pull Secondary Air Pump Relay -J299- -arrow- off relay plate in control module protective housing.
NOTE:
-
If tools are necessary to pull relays or control modules out of the relay plate, first disconnect battery Ground strap.
-
Before disconnecting battery Ground strap obtain code for radios with anti-theft coding.
-
Using adapter cables from VAG 1594 connect the VAG 1527B voltage tester to terminals 3 and 4 on relay plate.
-
Perform Output Diagnostic Test Mode (DTM) again and activate Secondary Air Pump Relay -J299-.
LED must flash
LED flashes:
-
Proceed with Output Diagnostic Test Mode (DTM) until completed.
-
Switch off ignition.
-
Replace Secondary Air Pump Relay -J299-.
-
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory, checking and erasing DTC memory. See: Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Read readiness code. If DTC memory has been erased or Motronic Engine Control Module (ECM) -J220- was disconnected from battery positive
(B+), readiness code must be generated again. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes See: Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
LED does not flash:
-
Using adapter cables from VAG 1594 connect the VAG 1527B voltage tester to terminal 3 of relay plate and body Ground.
LED must light-up
LED does not light-up:
-
Proceed with Output Diagnostic Test Mode (DTM) until completed.
-
Switch off ignition.
