New Beetle GLS L4-1.8L Turbo (AWV) (2001)
/Page-645002.png)
If the specifications are obtained:
-
Press -> button.
-
Remove engine speed adjuster VAG 1788/10 from accelerator pedal.
-
Press buttons -0- and -6- for function "End output" and confirm entry with -Q- button.
-
Switch off ignition.
Continuation
If the specifications are not obtained:
-
Remove engine speed adjuster VAG 1788/10 from accelerator pedal.
-
Road test vehicle to free oxygen sensor of possible contaminates and repeat test.
Observe the valid safety precautions when road testing.
If the specifications are again not obtained:
-
Replace oxygen sensor after Three Way Catalytic Converter (TWC) -G130-.
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory, Checking and Erasing DTC Memory. See: Computers
and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Read readiness code. If DTC memory has been erased or Motronic Engine Control Module (ECM) -J220- was disconnected from battery positive,
readiness code must be generated again.
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Not Available For Generic Scan Tool
This test is not available for the generic scan tool
