New Beetle GLS L4-1.8L Turbo (AWV) (2001)
/Page-21001.png)
Electronic Brake Control Module: Service and Repair
ABS control module and hydraulic unit, removing and installing
Required special tools and equipment:
^
VAG 1331 Torque wrench or equivalent
^
VAG 1410 Torque wrench or equivalent
Additional information:
CAUTION! Before working on any part of the brake system, read CAUTIONS and WARNINGS, Refer to Service Precautions.
Location
The control module is attached to the hydraulic unit and is located on the left side of the engine compartment.
CAUTION! Do not bend brake lines at the hydraulic unit.
Removing
^
Obtain radio code for vehicles with coded radio.
^
Disconnect battery.
^
Remove intake hose -1. and connector -2- from Mass Air Flow (MAF) Sensor.
^
Remove bolts -4- and -5-.
^
Remove air cleaner as complete unit.
^
For vehicles with Diesel engines, remove relay panel above brake booster.
WARNING!
^
Brake fluid is poisonous.
^
To draw off brake fluid from the reservoir use a bleeder bottle used only for brake fluid. Never siphon brake fluid by mouth.
