New Beetle GLS L4-2.0L (AVH) (2001)
-
Pull harness through grommet to second assembly mark on harness.
Note:
You must also pull the single wire portion of engine overlay harness to the plenum along with main portion of overlay harness.
1998 m.y. only
-
Partially remove foam (arrow) where wiring harness from plenum routes through to engine compartment (under previously removed wiring
harness channel cover).
-
Continue overlay harness routing (single wire) in plenum to left side of vehicle route along existing harness to 10 pin connector (arrow).
Note:
Add wire Part No: 000 979 981 as necessary to reach connector.
Separate and inspect connector for contamination:
1. Clean connector housing as necessary, replace contaminated terminals as necessary (except cavity 9).
2. Remove pin (brown/white wire) from cavity 9 of this connector.
3. Go to all m.y.
1999-->2001 m.y.
-
Continue overlay harness routing (single wire) in plenum to 10 or 14 pin connector near ECM.
Inspect connector for contamination:
1. Clean connector housing as necessary, replace contaminated terminals as necessary (except cavity 9).