New Beetle GLS L4-2.0L (AVH) (2001)
-
Remove union nut using 3217 wrench.
-
Pull fuel delivery unit and seal out of fuel tank opening.
NOTE: If the delivery unit being replaced; properly drain old delivery unit before disposal.
Installing
Installation is carried out in the reverse order of the removal procedure.
NOTE:
-
Do not bend the fuel sensor when installing.
-
Insert seal for fuel delivery unit dry into opening of fuel tank.
-
Moisten seal with fuel only when installing fuel delivery unit.
-
Ensure that fuel hoses are securely seated.
-
Note installed position of fuel delivery unit flange: Mark on flange must align with mark on fuel tank -arrows-.
-
After installing fuel delivery unit, check that the supply, return and vent lines are still clipped to the fuel tank.
-
Check DTC memory:
-
Match Engine Control Module to Throttle Control Module:
-
Check Readiness code:
-
If DTCs are stored in the ECM or ECM receives low voltage when ignition is on, Readiness code must be reset: