New Beetle GLS L4-2.0L (AVH) (2001)
-
Check wires between test box and 4-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram. Terminal 2 +
socket 28: Wire resistance: max. 1.5 Ohms
Vehicles with engine code AVH, AZG, BDC
-
Check wires between test box and 4-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram. Terminal 2 +
socket 63: Wire resistance: max. 1.5 Ohms
Continuation for all vehicles
-
Also check wires for short circuit to B+ and Ground (GND): Specified value: Infinite Ohms
-
Check wire between 4-pin connector terminal 1 and Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram: Wire resistance:
max. 1.5 Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
With Manufacturer Scan Tool
Heated Oxygen Sensor (HO2S) For Oxygen Sensor After Catalyst, Checking
Special tools and equipment
-
Scan tool VAG 1551 or vehicle system tester V.A.G 1552 with cable VAG 1551/3B
-
Test box V.A.G 1598/31
-
Hand multimeter V.A.G 1526 or multimeter V.A.G 1715
-
Adapter set V.A.G 1594
-
Wiring diagram
Check conditions
-
All fuses must be OK
-
The battery voltage must be at least 11.5 V
-
Fuel pump relay must be OK