New Beetle GLS L4-2.0L (AVH) (2001)
-
Remove VAG 1788/10 from vehicle to bring engine down to idle
-
Press (<) button two times
-
Select "15 - Check readiness code"
-
Readiness code should read 00000000
-
Press "Print" button for copy to attach to repair order
-
Press (<) button
-
If vehicle has automatic transmission, turn ignition switch to "OFF" position, press (<) button and proceed to Section F, otherwise go to next step
-
Select "06 - End Output"
-
Switch ignition to "OFF" position
NOTE: The coding values entered and shown on the display will not be used by the Motronic Control Module UNTIL the ignition has been
switched OFF once
-
Disconnect VAS 5051 / 6 diagnostic cable harness from data link connector
-
Remove CD ROM from VAS 5051 vehicle diagnostic tester
Section F
Section F - Automatic Transmission - Initiating Basic Settings
-
Turn ignition switch to "ON" position
-
Select "02 - Gearbox Electronics"
-
Select "02 - Interrogate fault memory"
-
Press (<) button
-
Select "05 - Erase fault memory", if required
-
Press "OK " button
-
Press (<) button, if faults erased
-
Select "04 - Initiating Basic Settings"
-
Press -0- button for Display Group 0: Basic Setting
-
Press "Q" button to confirm
-
Depress accelerator pedal as far as kick down and hold in this position for 3 seconds
-
Press (<) button
-
Select "06 - Exit program"
-
Release accelerator pedal
-
Switch ignition to "OFF" position
NOTE: The coding values entered and shown on the display will not be used by the Motronic Control Module UNTIL the ignition has been
switched OFF once
-
Disconnect VAS 5051 / 6 diagnostic cable harness from data link connector
-
Remove CD ROM from VAS 5051 vehicle diagnostic tester
-
Destroy and properly dispose of any removed parts