volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Operational Readiness Oxygen Sensor|Page 738 > < Operational Readiness Oxygen Sensor|Page 736
Page 3
background image

If the specifications are not attained:

-

Carry out a road test to free oxygen sensor of possible residues and repeat the test.

Observe the valid safety precautions when carrying out a road test.

If the specifications are again not attained:

-

Replace oxygen sensor before catalyst (G39)

-

Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory. Refer to "Displaying and Reading Trouble Codes/With
Manufacturers Scan Tool/DTC Memory Checking and Erasing" See: Powertrain Management/Computers and Control Systems/Testing and
Inspection 

-

Read readiness code. If DTC memory has been erased or engine control module was disconnected from permanent positive, readiness code must
be generated again.
Refer to "Monitors, Trips and/or Drive Cycle/Readiness Code, Displaying" See: Powertrain Management/Computers and Control Systems/Testing
and Inspection 
Refer to "Monitors, Trips and/or Drive Cycle/Readiness Code, Generating" See: Powertrain Management/Computers and Control Systems/Testing
and Inspection 

Oxygen Sensor Aging After TWC, Check

Oxygen Sensor After Catalyst Aging, Checking

Special tools and equipment

-

Scan tool VAG 1551 or vehicle system tester V.A.G 1552 with cable VAG 1551/3B

-

V.A.G 1788/10 Engine speed adjuster

Test conditions

Coolant temperature must be at least 85 °C See display group 04, display zone 3

Functional check

-

Connect scan tool VAG 1551 (V.A.G 1552). Start engine and select "Address word" 01 of engine control module. Engine must be running at idle
speed.

Connecting scan tool and selecting Engine Control Module (ECM). Refer to "Scan Tool Testing/Scan Tool Connecting and Initial
Checks/VAG1551 Scan Tool" See: Powertrain Management/Computers and Control Systems/Testing and Inspection 

Indicated on display

Rapid data transfer 

HELP

Select function XX

-

Press buttons 0 and 4 for function "Basic Setting" and confirm entry with Q button.

Indicated on display

Basic setting
Input display group number XXX

Operational Readiness Oxygen Sensor|Page 738 > < Operational Readiness Oxygen Sensor|Page 736