New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
Rear brake caliper piston, removing and installing
Special tools and equipment
^
3272 Resetting and removal tool
^
3409 Wedge
^
Bleeder container
Removing
-
Remove piston out of brake caliper housing by turning the knurled wheel counter-clockwise.
Note:
^
Install special tool 3272 so that the collar (arrow) is before the piston.
^
If piston is difficult to move, use a 13 mm (0.512 inch) AF open end wrench on the flats (arrow A) provided for this purpose.
-
Remove seal using wedge 3409.
Installing
-
The surface of the piston and seal must only be cleaned with methylated spirits and then dried.