New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
^
Select backward arrow on navigation bar.
^
Select diagnosis function "022 - End output".
^
Switch ignition OFF.
^
Proceed to "Checking Wiring".
Continuation of Check When Display Approx. 140°C (284°F)
Disconnect 4-pin connector from Engine Coolant Temperature (ECT) Sensor -G62- (arrow).
If display jumps to approx. - 40°C (- 40°F):
^
Select backward arrow on navigation bar.
^
Select diagnosis function "022 - End output".
^
Switch ignition OFF.
^
Replace Engine Coolant Temperature (ECT) Sensor -G62-. See ElsaWeb.
^
Check DTC memory, if necessary, repair any malfunctions and then erase DTC memory.
^
Read readiness code. If DTC memory has been erased, readiness code must be generated again.
If display remains at approx. 140°C (284°F):
^
Select backward arrow on navigation bar.
^
Select diagnosis function "022 - End output".
^
Switch ignition OFF.
^
Proceed to "Checking Wiring".
Checking Wiring
Tip:
Refer to applicable Repair Manual section for instructions regarding engine or diesel control module access.