New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
Catalytic Converter: Testing and Inspection
With Generic Scan Tool
Catalytic Converter, Checking
Function test
-
Select the measuring value "Test-ID 01: Catalytic converter" and check whether the specified values are being reached, Diagnostic mode 6: Check
test results of components that are not continuously monitored. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 6: Check Test Results of Components That Are Not
Continuously Monitored
-
End diagnosis and switch ignition off.
If the specified values are exceeded:
-
Replace the front exhaust pipe with catalytic converter, item 4.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Powertrain Management/Computers
and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase
Diagnostic Data
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles
and Readiness Codes