New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
/Page-796003.png)
-
Pull fuse No. 32 out of fuse holder.
NOTE: Removing fuse 32 interrupts the voltage supply to the fuel injectors.
-
Connect VAG 1527 voltage tester with adapter cables from VAG 1594 to terminals of disconnected connector
-
Contacts 2 + 3
-
Operate starter and check ignition signal from Engine Control Module. LED must flicker
-
Switch off ignition.
When the LED flickers and the supply voltage is OK:
-
Replace ignition coil with power output stage, item 2.
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory, Checking and Erasing DTC Memory. See: Computers
and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Read readiness code. If DTC memory has been erased or Engine Control Module was disconnected from battery positive, readiness code must be
generated again.
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
The LED does not flicker:
-
Check wiring.
Checking wiring
-
Remove inner plenum chamber cover, left.
