New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
readiness code must be generated again.
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If display remains at approx. 143.0 °C:
-
Press -> button.
-
Press buttons -0- and -6- for "End output" function and confirm input with -Q- button.
-
Switch off ignition.
-
Check wiring using Electrical Wiring Diagram.
Checking wiring
-
Remove inner plenum chamber cover, left.
-
Connect VAG 1598/31 test box to control module wiring harness. Motronic Engine Control Module (ECM) -J220- is not connected by this action.
-
Disconnect 4-pin connector from Engine Coolant Temperature (ECT) sensor -G62- with Engine Coolant Temperature (ECT) sensor -G2- -arrow-.
-
Check wire for open circuit between test box and 4-pin connector using Electrical Wiring Diagram.
-
terminal 3 + Socket 93
-
terminal 4 + Socket 108
Wire resistance: max. 1.5 Ohms
-
Check wiring between test box and 4-pin connector terminal 3 for short circuit to wire terminal 4 and to vehicle Ground (GND) using Electrical
Wiring Diagram.
-
terminal 3 + socket 108
-
terminal 3 + vehicle Ground (GND)